[Tigers] engine mounts

[Jim]

I used mounts from Sunbeam Specialties with no problems... I have no  idea
where Rick gets them from, though.
Something I highly recommend is putting 'safety' bolts in the mounts before
you install them. I did this using pictures from Tim Ronak's 'Lunati 350'
article on the TU site... I used 3/8" flat socket head bolts and left the
nylocks a tad loose for movement. Only special tool needed is a large
countersink bit... simple fix for a whole lot of peace of mind...

http://www.tigersunited.com/techtips/RonakCam/pt-RonakCam5.asp

Jim
382000446



-----Original Message-----
From: tigers-bounces+jim=island.net at autox.team.net
[mailto:tigers-bounces+jim=island.net at autox.team.net] On Behalf Of
CoolVT at aol.com
Sent: May 3, 2008 7:44 AM
To: tigers at autox.team.net
Subject: [Tigers] engine mounts

So listers, are TRW mounts available?  Where?  Where is  another good source

of mounts that fit and are of decent quality?  I tried  some from NAPA and 
another national chain.......metal about 1/3" thinner than  original, holes
off 
by at least 3/4" and the rubber on one mount about 1/2"  thinner than the 
other.  Both tried were import Asian products.  Wow,  I can see trying to
cheapen 
them, but is anyone actually bolting these on to a  Tiger or Mustang????
Mark



**************Wondering what's for Dinner Tonight? Get new twists on family 
favorites at AOL Food.      
(http://food.aol.com/dinner-tonight?NCID=aolfod00030000000001)
You are subscribed as jim at island.net

Tigers at autox.team.net
http://autox.team.net/mailman/listinfo/tigers

http://www.team.net/archive