[Tigers] Tigers Digest, Vol 9, Issue 141
Tom Witt
atwittsend at verizon.net
Thu Jul 20 09:12:57 MDT 2017
Is it possible (I don’t know SCCA rules) to have a roll bar that fits under the hard top, but has provisions for a slide in (and pin) or a bolt on “U” extension that rises above those whose height requires such???
From: Rob Hogan via Tigers
Sent: Wednesday, July 19, 2017 5:54 PM
To: tigers at autox.team.net
Subject: Re: [Tigers] Tigers Digest, Vol 9, Issue 141
Larry,
Adding the roll bar is a definite must do for track use and frankly as a structural stiffening in road use. I never seriously considered track runs with just a hard top. The questions in my planning are which configuration: ether a full width bar, a double hoop pair of roll bars or a slanted partial hoop bar with a reduced height diagonal on the passenger side should be used to minimize weight while attaining roll over protection; most likely where no passenger is present.
Rob Hogan
Retired Mechanical Design Engineer
B382001560
---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/tigers/attachments/20170720/5d42be8a/attachment.html>
More information about the Tigers
mailing list