Does anyone know how the rear interior panel and the quarter panels over
the wheel arches were originally clipped into place in a Series II car?
The holes in my sheet metal are not the same size as the door panel clips,
but I have contemplated drilling them out so that I can use the door panel
clips if I can't get the original parts. Also, in the rear panel there
was a plastic cup that the cable pull ran through. I understand from
Smitty down in San Diego that this part is not available anywhere. Any
suggestions on how to finish off these two holes?
Bill Lewis
Series II mutt
This archive was generated by hypermail 2b30 : Tue Sep 05 2000 - 09:16:42 CDT