Reply to: RE>Spokes
Buy a good HEAVY duty hub puller. I bought mine from Sears/Craftsman. Only
use two bolts. If you use three you'll never get the torques even. Tighten
it up and get your biggest hammer. Then do what comes naturally. The other
way to remove them is to pull out the axle with the hub and press them off.
Be sure to only loosen the nut (do not remove!) so when it comes loose it does
not shoot off. Tom
--------------------------------------
Date: 11/20/95 7:55 PM
To: T Wiencek
From: EJMW(at)aol.com
Anyone know if there is some special trick to getting the splined hub for my
spoked wheels off the rear axle.
I have removed the locking nut inside but still no luck.
Any ideas would be a big help.
thanx
Eric
------------------ RFC822 Header Follows ------------------
Received: by qmgate_backup.anl.gov with SMTP;20 Nov 1995 19:53:50 -0600
Received: by alpine.b17a.ingr.com (5.65c/1.921207)
id AA04279; Mon, 20 Nov 1995 19:33:02 -0600
Received: from b17a_pn.b17a.ingr.com by alpine.b17a.ingr.com (5.65c/1.921207)
id AA04275; Mon, 20 Nov 1995 19:32:50 -0600
Received: from triumph.cs.utah.edu by b17a_pn.b17a.ingr.com (5.65c/1.921207)
id AA05227; Mon, 20 Nov 1995 19:45:40 -0600
Received: from emout06.mail.aol.com (emout06.mail.aol.com [198.81.10.43]) by
triumph.cs.utah.edu (8.6.12/) with ESMTP id SAA29078 for
<alpines(at)autox.team.net>; Mon, 20 Nov 1995 18:31:49 -0700
From: EJMW(at)aol.com
Received: by emout06.mail.aol.com (8.6.12/8.6.12) id UAA14519 for
alpines(at)autox.team.net; Mon, 20 Nov 1995 20:31:48 -0500
Date: Mon, 20 Nov 1995 20:31:48 -0500
Message-Id: <951120203145_28922200(at)emout06.mail.aol.com>
To: alpines(at)autox.team.net
Subject: Spokes
This archive was generated by hypermail 2b30 : Tue Sep 05 2000 - 09:18:28 CDT