>> I just replaced thhe master cylinder on my 62 alpine and rebuilt the slave
>> yet I must repeatedly pump the cluth on order to accumulate enough presure
> to
>> disengage the clutch.
>> Any ideas befor I replace the slave too would be appreciated.
>>
>> Eric
>
>Sounds like you haven't gotten all the air out. Rebleed the system.
>Also check to make sure the slave isn't installed incorrectly. It's
>kinda embarrassing to admit but I installed the slave upside down on
>my snake. This put the bleeder valve below the inlet line making it
>nearly impossible to bleed all the air out.
>
>Roland
>
>If this is confession time, I did the exact same thing. "Nearly
>impossible"? I'd go as far as saying "impossible"!
>
>Jay
>
Yep, I could not figure why mine would not bleed either.I finally got the
air out by bleeding through the actual conn. to the slave cylinder !!
What a bunch of dummies, Eh? By the way Jay ... Whistler is Open!!
Tony Leeming
62 Ser II Alpine
69 MGB GT
76 450 SLC
83 Toyota Landcruiser
This archive was generated by hypermail 2b30 : Tue Sep 05 2000 - 09:18:48 CDT