Hub/axle shaft diameters.

From: T Wiencek (t_wiencek(at)qmgate.anl.gov)
Date: Wed Jan 22 1997 - 10:31:44 CST

Next message: Karl Gilchrist: "Fuel Additives"
Previous message: FRITZWICH(at)aol.com: "Holbay Alpines"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]

Subject: Time: 10:26 AM
OFFICE MEMO Hub/axle shaft diameters. Date:
1/22/97

Does anyone know the different sizes for the rear Hub/axle shaft diameters? I
have a set of wire wheel hubs and the maximum diameter of the hole measured
from the side that mates with the axle is 1.125 inches. Are these the early
hub (Series I-IV) or the Series V Hubs? Anyone have a some axles out to
measure the maximun diameter of the tapered end? This would answer my
question too. Thank you. Tom

Next message: Karl Gilchrist: "Fuel Additives"
Previous message: FRITZWICH(at)aol.com: "Holbay Alpines"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]

This archive was generated by hypermail 2b30 : Tue Sep 05 2000 - 09:32:53 CDT