From: Chris S. Mottram(at)ECCI on 08/03/97 10:25 PM
Thanks for all the turn signal help. I am going to check the wiring for a
bad spot AND add the ground wire to the signal lamp housing.
Lately, when I start my series 5, the oil pressure is 0 for about 2 seconds
then it jumps up like someone was holding the gauge needle and then let it
go. It used to just ease up to 40 lbs upon startup. Is there some sort of
valve or something in the pressure gauage line (or engine) that could be
sticking to cause this? Is it just a gauge problem? Or......gulp.....the
sing of something bad about to happen?
Thanks,
Chris
This archive was generated by hypermail 2b30 : Tue Sep 05 2000 - 09:49:37 CDT