Re: Stop the bleeding!

From: Ron Tebo (tebomr(at)cadvision.com)
Date: Fri Nov 21 1997 - 04:57:44 CST

Next message: Jay Laifman: "Reversing Lights"
Previous message: eckert(at)tfn.com: "Back-up Lights"
In reply to: James Downing: "Stop the bleeding!"
Next in thread: John Souders: "RE: Stop the bleeding!"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]

James Downing wrote:
>
> I don't mind a little oil drippage but enough is enough. In an attempt to
> stop the bleeding, I'm replacing the cork gasket on the pushrod inspection
> plate. Should the screws have thread sealer applied to them on replacement?
> If so, how much and what kind? Will it stand up to the heat?
>
> James (in a puddle o' crude)
> SII B9119860 OD LRX

James:

For a complete rundown on using thread-sealers and almost all Loctite
products, go to http://www.loctite.com.au/products.htm

Ron Tebo

Next message: Jay Laifman: "Reversing Lights"
Previous message: eckert(at)tfn.com: "Back-up Lights"
In reply to: James Downing: "Stop the bleeding!"
Next in thread: John Souders: "RE: Stop the bleeding!"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]

This archive was generated by hypermail 2b30 : Tue Sep 05 2000 - 10:02:39 CDT