Stop the bleeding!

From: James Downing (downing(at)mlml.calstate.edu)
Date: Thu Nov 20 1997 - 13:39:42 CST

Next message: Jarrid Gross (Yorba Linda, CA): "RE: Stop the bleeding!"
Previous message: Bob Hamilton: "RE: Upper Fulcrum Pins"
Next in thread: Jarrid Gross (Yorba Linda, CA): "RE: Stop the bleeding!"
Maybe reply: Jarrid Gross (Yorba Linda, CA): "RE: Stop the bleeding!"
Maybe reply: John Souders: "Re: Stop the bleeding!"
Reply: Ron Tebo: "Re: Stop the bleeding!"
Maybe reply: John Souders: "RE: Stop the bleeding!"
Maybe reply: Jarrid Gross (Yorba Linda, CA): "RE: Stop the bleeding!"
Maybe reply: Lauri Lehtinen: "Re: Stop the bleeding!"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]

I don't mind a little oil drippage but enough is enough. In an attempt to
stop the bleeding, I'm replacing the cork gasket on the pushrod inspection
plate. Should the screws have thread sealer applied to them on replacement?
If so, how much and what kind? Will it stand up to the heat?

James (in a puddle o' crude)
SII B9119860 OD LRX

Next message: Jarrid Gross (Yorba Linda, CA): "RE: Stop the bleeding!"
Previous message: Bob Hamilton: "RE: Upper Fulcrum Pins"
Next in thread: Jarrid Gross (Yorba Linda, CA): "RE: Stop the bleeding!"
Maybe reply: Jarrid Gross (Yorba Linda, CA): "RE: Stop the bleeding!"
Maybe reply: John Souders: "Re: Stop the bleeding!"
Reply: Ron Tebo: "Re: Stop the bleeding!"
Maybe reply: John Souders: "RE: Stop the bleeding!"
Maybe reply: Jarrid Gross (Yorba Linda, CA): "RE: Stop the bleeding!"
Maybe reply: Lauri Lehtinen: "Re: Stop the bleeding!"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]

This archive was generated by hypermail 2b30 : Tue Sep 05 2000 - 10:02:37 CDT