Paul,
You should be able to knock it out from the outer side using a long
screwdiver going through the hub. Make sure you don't hit the bearing or
you may damage it. This may or maynot destroy the seal depending on how
hard it is to get out. They are cheap so it's always safer to replace
it.
Good Luck,
Sergio
Paul Heuer wrote:
>
> HELP!
> Can someone describe a method to remove the seal on the front disk rotor
> that keep the wheel bearing grease in the wheel bearing? I have the hub
> and rotor assembly off my Series 3 and want to repack the bearings, but
> I can't get the inner bearing out!
>
> Cheers,
> Paul.
> --
> Paul Heuer paul.heuer(at)dsto.defence.gov.au
> Defence Science and Technology Organisation
> Air Operations Division - Salisbury Phone: +61 8 8259 5109
> PO Box 1500, Salisbury, South Australia, 5108 FAX : +61 8 8259 5507
This archive was generated by hypermail 2b30 : Tue Sep 05 2000 - 10:04:02 CDT