Bill Harben writes:
" I noticed the intake and exhaust manifolds are attached
to the block of my 1725cc using the same bolt at the most forward point.
However, I also noticed that each manifold is a different thickness,
differing by almost 3/8 inches. This bolt looks as though it needs some
sort of odd shaped spacer. Is this true?"
On my SV, when stock, the exhaust manifold and intake manifold matched
exactly. I would suspect that you have an after market exhaust. Which one
is the thicker one? Do you have the stock dual Strombergs? Is your
exhaust manifold a thick cast iron piece that, from top to bottom,
vertically, is about 7-8" long?
Jay
This archive was generated by hypermail 2b30 : Tue Sep 05 2000 - 10:06:06 CDT