----------
From: Jay Laifman
>I think I have seen someone with a Sunbeam roll bar that could remove.
The
>tubes were cut about 6" above the mounts, a smaller tube, with an OD =
to
>the ID of the roll bar tubes, was welded inside of the short tubes
>connected to the mounts. These short tubes would extend up into the
cut
>off part of the roll bar, with bolts through to hold it on.
>Wouldn't the
>integrity of the bar be sacrificed with this set up?
Yeah, And it nearely defeats the purpose of having a solid thickwall
tube as a rollbar.
You would not do a lot of racing with that bar, although it is probably
convenient as hell.
Jarrid
This archive was generated by hypermail 2b30 : Tue Sep 05 2000 - 10:10:15 CDT