Re: Transmission Interchangability

Barrie Henderson (hendersb(at)direct.ca)
Tue, 02 Jun 1998 17:32:53 -0700


Jarrid Gross (Yorba Linda, CA) wrote: >
> Tom Hill wrote,
>
> >Can a series V transmission be used in series II car? What mods, if
> >any, are required?
>
> Good news!
> Tranny is a bolt in, Use the throw-out fork and throw out bearing
> from the tranny that is aleady in your SII though, the fork and bearing
> are for a given clutch setup, and not the type tranny used.
>
> Oh, and remember reverse is on the opposite side of the H pattern.
>
> Jarrid Gross

Having no value to anyone - but I used to take a secret delight in the fact that I might thwart any would be thieves of my SIV - with it's SV 1725 cc and all syncro tranny - by having a pre-syncro gear shift knob - showing reverse on the left of the "H" instead of where it really was on the right (did I get that right - or is that backwards?).

I had this 'vision' of the thief trying to back it down my driveway onto the street (assuming of course he could get it started at all) - and turning the whole gearbox into a pile of 'hamburger' in the bottom of the case in the process. But he would'nt get My Alpine!

Barrie Henderson