You can find a wiring diagram for the Series I Alpine at http://www.mindspring.com/~teae/awire1.gif
Using the wiring diagram and a continuity tester, you can eventually track down the component that burned out. Check the fuses (on driver side in engine compartment on a Series IV), and your control box near them. Since you indicate that the WHOLE system is dead, then I would suspect components within the ignition switch circuit.
Debugging electrical problems is hit and/or miss. I once tracked down a problem with my Alpines' headlight switch in this manner, but it took longer than I'd like to admit.
Good luck.
Brad
Robert Wiseman wrote:
>
> I am having a problem with my electrical system. I am working on a car
> that has been garage and not run for 20 yrs. While trying to start it
> the other evening, there was a pop and the entire electrical system went
> dead. The question is what is the best way to track the short. Keep in
> mind your are dealing with a novice. Any help would be appreciated.
> Thanks, Rob 1961 Alpine Series I
