Jarrid Gross wrote:
> >I could use a little knowledge booster. Paul needs a sway bar. I have a
> >couple. I have no idea if these swaybars will fit Pauls series 3. I
> >don't want to ship him the wrong part. Any ideas?
>
> Unless you have a reference piece to compare to, it will be tough to
> determine what series that the bar belongs to by sight.
>
> Series IV and V seem to have the same bar, unless a larger bar
> has been fitted.
> Stock is 5/8 inch. Tigers used 3/4, and replacements are available
> to 1 1/8 inch.
>
> Series I to III have a slightly different bar, which clears the
> crossmember weld lip. Later cars dont have the weld lip on the
> crossmember, so these bars dont protrude quite as far foreward.
>
> There is also some minor differences in the angles that the bar
> ends are bent to, which in the case of larger bars wont be able
> to be mounted even with the interferance.
>
> Hope this helps.
>
> Jarrid
Chris:
To add to what Jarrid said, Series I and II used Part #1201492, Lemans and
all Series III used Part # 1210473, and Series IV onwards used Part #
1210242.
Ron Tebo
This archive was generated by hypermail 2b30 : Tue Sep 05 2000 - 10:45:16 CDT