Dash reassembly cont'd...
The insulation on most of the hot wires leads to the instrument back
lighting is partially melted. A couple of areas have burned through
revealing lightly corroded (dull looking, but not quite green yet) copper
wire. Obviously I will replace these wires. Would corrosion have created
resistance causing the insulation to melt or do I have a problem lurking
elsewhere?
Scott Donnelly
SV
PS. Toggle switch ring tool - make your own - a 10 minute job! Thanks.
This archive was generated by hypermail 2b30 : Tue Sep 05 2000 - 10:49:01 CDT