1.) I found the gas pedal in the trunk. Just using the rod which the pedal
attaches to now. How does the pedal attach to the rod? Is there a pivot
point on the bottom of the pedal which attaches the pedal to the floor and
then the pedal bracket on the backside of the pedal allows the rod to slide
in its slot?? Help? Also, what if anything, goes on the end of the rod to
hold the pedal on?
2.) I found that the windshield washer sprayers also make good funnels for
water getting into the car..:>) There are no gaskets! I have the crome
top nozzel and its base and the brass part that threads into it from the
bottom. Are there any other pieces besides the gasket? Such as a small
plate on the which goes against the gasket that the brass part pushes
against as you tighten it down?
3.) I have Rostyle rims from a Capri (What years?). Not crazy about these.
Not interested in wires. What else fits that might be available from a
junk yard or cheap? I know the bolt spacing is 4x108mm, what is the back
spacing? Anything else I should know here?
4.) I need the boot lid lock braket, etc. Basically the whole assembly.
It is pictured on page 22, section o, fig 33, in the manual. I do not need
the striker plate. I do have that. Help?
Thanks in advance, you are all very helpful.
I do have a spare door crank handle....
L.D. Moore
This archive was generated by hypermail 2b30 : Tue Sep 05 2000 - 10:52:07 CDT