"Silverstein, Steve" wrote:
> I am about to change the timing chain on my SV. Has anyone done this
> recently? The question I have revolves around the bolt that holds the
> crankshaft pulley on.
>
> I think it requires a 1 5/16in Deepwell Socket due to the crank chuck that
> extends out from the bolt. Am I right on the size of the socket required?
I do not know the size,BUT.
>
>
> This is a difficult socket to find cheaply. Sears has a large deepwell set
> for $87.00 made by Ingersol/Rand...I haven't checked with the Snap-On
> dealer. Are there any other alternatives sources through mail order (I
> looked through JC Whitney but nothing was listed).
>
I was looking for a single 1" for my tranny fill hloe. I happened to pass a used
tool store and they had several sizes all loose. You may check on those type
stores if you have them available. Total cost of trip $3.50 US.
Good luck
chuck
This archive was generated by hypermail 2b30 : Tue Sep 05 2000 - 10:55:17 CDT