>From: Sunbmsandy(at)aol.com
>
>Rick's recommendation was to clean the paint from the inside of the
>gas tanks, a job better left to a radiator shop. He said that there
>is a tank lining paint used in motorcycle tanks that would work,also
>a product offered by Bill Hirsch. Does anyone on the list have any
>experience with solving this problem, especially with a replacement
>tank lining product?
Though understandably biased, there's a good summary of the main
options on the Hirsh site at: http://hirschauto.com/sealer.htm
I had a radiator shop clean, solder the pin holes, and seal with the
common yellow PVC sealer for about $100 2 or 3 years ago. It works fine for
now, but I would go with the alcohol resistant version if I were doing it
today.
Can't say anything about the Hirsch sealer from experience. But have found
their documentation to give a very accurate representation on other products
of their's I've used.
Regards,
Bob Douglas
Dallas, TX
This archive was generated by hypermail 2b30 : Tue Sep 05 2000 - 10:55:42 CDT