Hi Brent , Sorry to hear all is not well with the ignition conversion.
Did this happen under heavy load or heavy acceleration and did you
experience a backfire? When you checked the rotor did you remove it and
put it back on or just look at it. When this happened to me it looked ok
at a glance but upon slowly removing it I discovered the ridge inside
the rotor did not line up with the notch in the dist shaft.
On the other hand could your wiring have come loose or lost contact
?
Keep us updated.
Rob Nanzig
67SV
P.S. In your email you refer to Tectronix- I assume you meant Pertronix
and that it is now working.
This archive was generated by hypermail 2b30 : Tue Sep 05 2000 - 10:55:49 CDT