Hi: Just a quick comment on an earlier post. The guarantee is 30 months,
not 30 days. Be sure all your connections are good, clean and tight. If
the rotor is installed correctly, the plate installed correctly and the
wiring connections good, this unit will perform very well over an extended
period of time. Good luck.
Paul from sunny South Dakota
robert nanzig wrote:
> Hi Brent , Sorry to hear all is not well with the ignition conversion.
> Did this happen under heavy load or heavy acceleration and did you
> experience a backfire? When you checked the rotor did you remove it and
> put it back on or just look at it. When this happened to me it looked ok
> at a glance but upon slowly removing it I discovered the ridge inside
> the rotor did not line up with the notch in the dist shaft.
> On the other hand could your wiring have come loose or lost contact
> ?
> Keep us updated.
>
> Rob Nanzig
> 67SV
>
> P.S. In your email you refer to Tectronix- I assume you meant Pertronix
> and that it is now working.
This archive was generated by hypermail 2b30 : Tue Sep 05 2000 - 10:55:51 CDT