Andy wrote,
>I'm trying to refit the overdrive to the gearbox. (63 ser III )
>I'm pretty sure the two sets of splines at the back of the OD are lined up,
>to within a degree or two, and the pump lobe on the box output shaft is set
>ok,
>but the OD still slides up the shaft and then stops with a 20mm gap between
>mating surfaces.
>( i.e. a few mm before the lobe engages the pump roller/arm )
If its not the lobe and roller holding you back, the tranny tail
shaft engages a 9/16" roller bearing in the anoulous. If the bearing
is buggered, or not alligned, it will not slide on.
Good luck.
Jarrid Gross
This archive was generated by hypermail 2b30 : Tue Sep 05 2000 - 10:55:53 CDT