Michael Fisher wrote:
> Hi Beamers,
>
> Seems I toasted a bearing in my differential this summer and had the
> differential sieze. (very exciting with wire wheels, you get to see one
> then the other roll down the road past you as the rear end falls on the
> road!) Anyway after replacing all of the bearings in the diff and
> rebuilding, I still have a very bad vibration in the rear end. I didn't
> think the pinion was bent when I rebuilt it but now I am not so sure.
> The vibration is very bad when under power but almost non-existent when
> coasting.
Mike , Tough break. One suggestion. You may take your drive line to a shop
that rebuilds them and have them check it out. If the tube is bent or
slightly twisted you will have viberations... A replacement shouldn't cost
(well in the NW) over 75.00.
Try it it may work
My 2.765 p
chuck
good luck
This archive was generated by hypermail 2b30 : Tue Sep 05 2000 - 08:35:15 CDT