Good morning, Group!
Reading the messages about that topic I found out, that probably I have
an
identical or similar problem:
After fitting the complete windshield to the body, and after fixing the
side windows to the doors, I got the following situation:
The gap between windshield and side windows is not parallel as it should
be. It diominishes from about 3/4 " (20 mm) on the bottom to 0 on the
top.
So it is also impossible to fix the rubber seals between windshield and
door!
See also the following sketch:
http://www.geocities.com/MotorCity/Downs/4199/pic-01.jpg
So I think, that there must be some kinds of washers or plates to be put
under the windshield frame at the location of the back bolts of the
frame.
Unfortunately I didnīt make any pictures or notes when disassembling the
car some (long) time ago!
So my question:
Can anybody assist me with that problem?
Does anyone know, if there are such washers or plates?
Where can I get them - or can anyone give me the dimensions?
Please respond, when possible, also with a copy to my office e-mail
adress:
andreas.pils(at)skf.com
Many thanks in advance, Andreas
Series V - Austria
This archive was generated by hypermail 2b30 : Tue Sep 05 2000 - 08:35:24 CDT
