GSTROM99(at)aol.com writes:
>OK, if you move the rear plate to below the bumper, what kind of mount
>do you
>use? More importantly, what do you use to seal the four holes that are
>left
>in the boot/trunk lid?
I fabricated a mount out of stainless steel angle iron that mounts to
the 2 bolts under the scuttle that hold the center fuel tank tube. I
then turned over the plate light mount and bent it to fit. Looks stock
in my opinion. I welded to trunk holes when the body and paint work
was done.
CNA
This archive was generated by hypermail 2b30 : Tue Sep 05 2000 - 08:41:41 CDT