Chuck,
>I finally put the Series ll on the ground after much work. full syncro
>tranny rebuilt, new clutch/ pressureplate/ thow out (solid ) bearing and
>all new seals. Here is the question and things that go thump.. After
>starting and backing out I heard a kinda rumble thump rattle.
>After taking it out for a spin the noise is appreant at idleing and
>going down the road it does'nt sound to drastic, but when I shut off
>the engine it sounds like it is still spinning and making that noise. It
>shifts great and appearently no problems are in the system.. I sure
>hate the thought of tearing it down again . Any suggestions?
>Thanks
>chuck ///ready for that proverbil brown bubbly.
Does it go away with the clutch depressed while in gear?
Does it go way when you are cruising in 4th?
If yes to both counts then perhaps it is the input shaft roller bearings.
Jarrid Gross
This archive was generated by hypermail 2b30 : Tue Sep 05 2000 - 08:55:58 CDT