Tom Yang wrote:
> Hello all,
>
> should I just use RTV,
NOT!
> or should I also use a gasket? I
> checked my box of spare parts and found the square gasket that fits to the
> block, but of course it is NOT the one I need! The leaking gasket is the
> one behind the hose fitting. Thanks!
>
Tom , I would, go to your local parts house get a package of gasket materials
and then completely remove all of the parts and make new gaskets.
Remember to use just a"small " amount of sealer on each side of the gaskets
just to hold them in place for asssembly. You can lay the material on the part
for an out line and use a sissor to cut it out. Then check fit size and put it
back together.
good luck
chuck
This archive was generated by hypermail 2b30 : Tue Sep 05 2000 - 08:59:33 CDT