Re: Main bearing rebuild

[VulForge@aol.com]

In a message dated 6/4/01 2:39:56 PM Central Daylight Time, Geegc@aol.com 
writes:


> What do you think could 
> cause the main bearings to go bad?  Do you think an entire rebuild is 
> needed 

Absolutely.  If the mains failed the other wear components will too.  Usually 
from under-lubrication, but can be from age, stress or contamination.   And 
it is NOT that much harder to do it right.  By the time you have the crank 
out the worst is over. Do it right so you don't have to do it over.

Russ
67 1600