Re: TRans mount ramblings...

[mike jackson <grand_wazoo@flinet.com>]

Yep, and the tabs we "made" were simply cut off a length of angle iron
and then drilled. 

I didn't even fill the center of the mount and have never broken one
again.

mike jackson

> After consultation with Bob Wismer we did the following:
> 
> 1. Fabricated two "L" shaped tabs and bolted them on either side of
> transmission mount for lateral support.
> 
> 2. Filled the gap between the upper & lower mounting plates with rubber
> for added vertical support.
> 
> No more problems encountered since then.
>