fot
[Top] [All Lists]

Wheel studs...again

To: Friends of Triumph <fot@autox.team.net>
Subject: Wheel studs...again
From: Joe Curry <spitlist@gte.net>
Date: Wed, 07 Feb 2001 17:59:29 -0700
I know I have asked this question before, but I am still seeking the right 
studs for my Spit racer.  I have installed TR6 studs per
mark B's recommendation, but they won't stay in the holes of the rear hubs.  If 
I hold tension on the wheelwhile I screw on the nuts, I
can get them on, but the splines are neither long enough nor large enough in 
diameter to stay in the holes. 

So I am back to looking for a source of the following studs:

Overall length = 1-1/4 to 1-3/8"
Thread size = 7/16x20
Shank length = 1/4"
Spline length = 1/4"
Spline diameter = .51" (the TR6 ones are .50)

Any suggestions would be most helpful.

Joe (C)

<Prev in Thread] Current Thread [Next in Thread>