Re: TR4A thru 6 Rear Hubs

["Gerald M Van Vlack" <jerryvv@alltel.net>]

Thanks to all who responded to my question regarding the IRS Hubs. It turns
out that those seemingly precise grooves that appear to be machined into the
bearing spacers are in fact worn areas resulting from the bearings being too
loose. One of the things I was overlooking was that this spacer is also the
seal race for the inner bearing seal. Those surfaces are very worn when
checked with a straight edge.

2 new spacers are on the way from TRF.

Thanks again.

Jerry Van Vlack