fot
[Top] [All Lists]

Re: [Fot] Corvair Hub End-Float

To: fot@autox.team.net
Subject: Re: [Fot] Corvair Hub End-Float
From: Robert Lang <lang@isis.mit.edu>
Date: Wed, 27 May 2009 07:58:40 -0400 (EDT)
Hi,

I'm doing my "last" nut/bolt check before running my car for the first 
time this season and I noticed that I have a bit of bearing play in my 
rear axles which are the Gp44 / Wingett corvair conversion.

I know squat about the hubs, but is there a way to set the end-float?

I'll probably run the car, but I need to convince tech that the setup is 
really "okay" before they give me an annual tech sticker.

Any pointers would be appreciated.
rml
---------------------------------------------------------------------------
Bob Lang              NER/SCCA                 |  This space for rent
Solo Chair 2008       TR6 40 F Prepared        |  Triumph!
Voice:781-438-2568    FAX: 617-258-9535        |  Cell: 339-927-4489
---------------------------------------------------------------------------
_______________________________________________
Support Team.Net http://www.team.net/donate.html

http://www.fot-racing.com

Fot mailing list
Fot@autox.team.net
http://autox.team.net/mailman/listinfo/fot

<Prev in Thread] Current Thread [Next in Thread>