fot
[Top] [All Lists]

Re: [Fot] Racing a TR3 A Type Overdrive

To: <Catpusher@aol.com>, <fot@autox.team.net>
Subject: Re: [Fot] Racing a TR3 A Type Overdrive
From: "MadMarx" <tr4racing@googlemail.com>
Date: Tue, 13 Nov 2012 18:26:55 +0100
Cc: HRPTR3@aol.com
Delivered-to: mharc@autox.team.net
Delivered-to: fot@autox.team.net
References: <1d843.28c659b5.3dd2ee48@aol.com>
Thread-index: Ac3BNfO4nBfv+A4xTtajXaCJlN8E6QAjb1qw
The only issue I have with a J-OD that it switched off during the race.
The OD always went out and popped in a very short manner.
No idea what this could cause.
- New solenoid (it happened with the old solenoid too)
- wiring is connected well
- oil level little higher than normal

Cheers
Chris


-----Urspr|ngliche Nachricht-----
Von: fot-bounces@autox.team.net [mailto:fot-bounces@autox.team.net] Im
Auftrag von Catpusher@aol.com
Gesendet: Dienstag, 13. November 2012 01:29
An: fot@autox.team.net
Cc: HRPTR3@aol.com
Betreff: [Fot] Racing a TR3 A Type Overdrive

Racing a TR3 A Type Overdrive
Please see what you can find in the archives.
For many years the TR3 was one of a very few cars  not allowed alternate
gearbox ratios in SCCA E Production. Using second gear  overdrive was
essential with a full race motor to bridge the gap between  2nd and 3rd. I
spent thousands of hours studying and  modifying the OD. Running a pressure
gauge during events is necessary, as is not  allowing it to leak on the
driver. The gauge will show when the solenoid is out  of adjustment, and
most critically, when there is a running pressure drop. If  the accumulator
piston does not reach the blow off holes, that oil no longer  gets to
several parts. The specks for the accumulator bore are very tight, and
honing to remove the steel piston ring scratches will only work a few times.
The  TR4A IRS/TR6 piston, sleeve, and spring provide a much lower volume and
pressure, but a replaceable sleeve is a good idea. Much research about
piston  displacement and pressure pointed me towards a Jaguar sedan assembly
that was  NLS, but JRT, with the help of a UK Jaguar club, provided a few
sets of piston  and sleeves, and I also located the matching springs. I did
find it necessary to  run an oil cooling system with an electric pump and
MGC auto gearbox cooler, all set low enough that it would not flow back into
the gearbox during the early laps before the pump was turned on. Keep in
mind that I was running slicks and  often ran where the track temps were
high.
TR Regards, Hardy
_______________________________________________
fot@autox.team.net

http://www.fot-racing.com

Archive: http://www.team.net/archive
Unsubscribe:
http://autox.team.net/mailman/options/fot/tr4racing@googlemail.com
_______________________________________________
fot@autox.team.net

http://www.fot-racing.com

Archive: http://www.team.net/archive
Unsubscribe: http://autox.team.net/mailman/options/fot/mharc@autox.team.net


<Prev in Thread] Current Thread [Next in Thread>