land-speed
[Top] [All Lists]

Re: Engine Turned Aluminum

To: land-speed@autox.team.net
Subject: Re: Engine Turned Aluminum
From: LGMCAFEE@aol.com
Date: Wed, 28 Mar 2001 21:00:47 EST
In a message dated 3/28/01 11:30:17 AM Central Standard Time, kturk@ala.net 
writes:

<< Hey guys speaking of metal.... how was the old Engine turned aluminum or
 stainless actually done?
 >>
There has been a lot of good suggestions on engine turning, the way I did the 
dash inserts on the Willys was to use scotts pads cut with a 1inch hole 
punch. Then I used a mandrel that had a pad on it that had hooks like velcro. 
This held the scotts pads in place and worked real good. I used my mill to 
get the pattern that I wanted after some trial and error. Larry Mac

///
///  land-speed@autox.team.net mailing list
///


<Prev in Thread] Current Thread [Next in Thread>