land-speed
[Top] [All Lists]

Re: %$#%#^@&#@^% -4 AN fittings and hoses

To: Nafzger <nafzger@vtc.net>
Subject: Re: %$#%#^@&#@^% -4 AN fittings and hoses
From: Joe Amo <jkamo@rapidnet.com>
Date: Fri, 23 Nov 2001 21:15:46 -0700
No Howard, we are >24hrs out now, and believe
me everyone is full of something, but its not turkey, or
possum, or whatever the hell the alabama gang eats
Joe

Nafzger wrote:

> mayf,
> Everyone is so full of turkey and stuffing that they can't reach the
> keyboard.
> Howard
>
> ----- Original Message -----
> From: "DrMayf" <drmayf@teknett.com>
> To: <land-speed@autox.team.net>
> Sent: Friday, November 23, 2001 6:35 PM
> Subject: %$#%#^@&#@^% -4 AN fittings and hoses
>
> > Since the list is quiet, I thought I'd ask about the easy way to
> assemble -4
> > AN fittings and stainless braided hoses. I'll bet this is the least uses
> > combination of all! What a chore. But I finally got one end done...lots of
> > trial and error practice. I finally cut the hose real square, wrapped with
> > tape naturally, then gently ground it smooth on the side of my grinder
> > wheel, carefully removed the tape (drat, some straggler strands escaped!),
> > carefully set the nut on the hose and then whapped it mightily on the end
> > with a non marring BOARD! Got that sucker on finally. Kept whapping it
> till
> > it was in too deep of course, so had to back it out a bit. Then put the
> > screw in part in and that was hard to get threadded, sheesh! This process
> > seemed to work ok...but, is there a better way? I will use nothing but -10
> > size from now on, no matter what it is for.....
> >
> > And why is the list so quiet except for some chat about auto trannies?
> >
> > mayf

///
///  land-speed@autox.team.net mailing list
///  To unsubscribe send a plain text message to majordomo@autox.team.net
///  with nothing in it but
///
///     unsubscribe land-speed
///
///  or go to  http://www.team.net/cgi-bin/majorcool
///
///


<Prev in Thread] Current Thread [Next in Thread>