land-speed
[Top] [All Lists]

Re: Trucks & roof rails

To: "Dave Seely" <dseely@sginet.com>, "W S Potter"
Subject: Re: Trucks & roof rails
From: "DrMayf" <drmayf@teknett.com>
Date: Wed, 21 Aug 2002 07:45:26 -0700
No cheating from me! Don't have a pickup...as to the low side flip, air gets
under the car and...the roof rails and flaps on the roof are to discourage
the air over thep,  preventing it from becoming an airfoil. If you look at
an installation, one is straight and one is at an angle. DOn't know about
the trucks...but as to the bed, I would require them on the tonneau also.
Small price to pay and no help for speed.

mayf
----- Original Message -----
From: "Dave Seely" <dseely@sginet.com>
To: "W S Potter" <wester6935@attbi.com>; "DrMayf" <drmayf@teknett.com>; "Dan
Warner" <dwarner@electrorent.com>; "land speed" <land-speed@autox.team.net>
Sent: Wednesday, August 21, 2002 6:16 AM
Subject: Re: Trucks & roof rails


> I remember seeing NASCARs sliding toward the infield and then rolling
UNDER!
> Not the typical, dig in the leading tires, highside roll but a low side
roll
> underneath (has anyone witnessed this on the salt?) sometimes without the
> top even touching the ground.  Then they started requiring roof rails and
> the panels that pop up when the airflow is backwards (these panels have
> restraining cables to hold them at an angle to the airflow like an
aircraft
> dive brake).  The roof rails probably create some aerodynamic stability
for
> straight ahead work, but are really an advantage in spoiling the crosswise
> airflow (and lift) across the top of the roof while in a slide.   Also if
> you ran the tonneau on the truck from the top, front lip of the bed, to
the
> tailgate hinge area, wouldn't the slab sides of the bed become huge
'rails'.
> Just a thought, no cheating out there, now.
> Dave Seely
> 1141 XF/VOT

///  unsubscribe/change address requests to majordomo@autox.team.net  or try
///  http://www.team.net/mailman/listinfo
///  Archives at http://www.team.net/archive/land-speed
///  what is needed.  It isn't that difficult, folks.


<Prev in Thread] Current Thread [Next in Thread>