Re: 9" Ford Pinion (1350 yoke)

["J D Tone" <gmc6power@earthlink.net>]

If this is your standard Dart Product I'll keep to my non bent engines


>> Referring to the cam bore over their own stated specs they said that 
>> figure
> was before its final hone. They could supply me a set of slightly oversize 
> OD bearings but didn't consider it justified. They said to purchase 
> oversize cam followers available from Crane to correct the lifter bores.
> Next they justified the tight crank tunnel by suggesting its easier to 
> take metal out that replace it.