Re: Spindle Torque (was Things to do---)

[Want1937hd@aol.com]

In a message dated 7/10/06 1:58:29 AM Eastern Daylight Time, 
wmtsmith@landracing.com writes:
I was taught to tighten untill you can just feel the drag--then back the 
castelated nut back to the previous slot...
As far as I know the Model T Ford (1909-27) was the only car to have outer 
cone bearings with a threaded inside. You tighten them up and them ran the 
castelated nut on that was in effect a jamb mut and then installed the cotter 
pin. 
Bob in connecticut