Bob:
Although Crane specified .018 Intake, and .020 exhaust, their engineers
told me to use .014 Intake and .016 Exhaust. I have done so since 1985, and
it runs great. It is sure being driven to Durango in June.
Skip.............................................At 03:46 PM 3/5/02 -0500,
Bob Howard wrote:
> Seems to me that one should set the clearances to the specifications
>of Crane, who made the cam that is in your engine.
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/mg-t
|