It sounds to me like all you need are new seals in the MC. It isn't hard
to do but if you get the redesigned seals take a good look at what you are
doing because the manual shows the originals and I ended up puting mine in
backwards because I was trying to use the haynes manual with the
redesigned seals. They are not hard to do and should fix your problem.
'71 B roadster
'74 BGT bastardization with big alluminum heart :)
On Tue, 3 Aug 1999, Robert Berning wrote:
> If I press the clutch in and hold it, it will start engaging and quickly
> fully engage the clutch. If I hold down the clutch and lift till it feel
> like it the clutch is engaged then press down again, the distance need for
> the clutch to engage decreases every time the petal is pushed to the floor.
> I would assume the fluid is leaking past the rubber seam, and not holding
> the pressure.
> I am pretty sure this means my clutch master cylinder is bad. Could it be
> something else?
> If it is the clutch master cylinder, should I try rebuilding it with a kit
> from Moss or just buy a new/rebuilt one from Moss? I would also
> change/rebuild the slave cylinder too.
> Thank you,
> Robert Berning