My MGA needs the cluctch hose replaced. I am assuming this is the case as the
clutch pedal goes to the floor and stays there then very slowly returns. I
have diagnosed this as a collapsed hose to the slave cylinder much like I have
experienced with brake hoses on my MGB. Since the engineering is the same as
for the B, in fact the hose is the same part number, I was curious if there is
an expeditious way to replace this hose. I have not done this in a long time
but do remember it is quite a small space down there. Any suggestions? It
would be the same procedure on a B.
Frank Krajewski
|