oletrucks
[Top] [All Lists]

Re: [oletrucks] 235 Timing Gear and Cam

To: Hudson29@aol.com, trks@javanet.com, oletrucks@autox.team.net
Subject: Re: [oletrucks] 235 Timing Gear and Cam
From: jvanho01@tir.com
Date: Thu, 22 Jul 1999 22:26:12 -0400
I agree with the part of where do you stop.  I was just going to do what
needed to be done on '58 GMC 336ci V8.  Well to make a long story short, I
have ended up with boring to .040 to correct wear which forced new pistons
and rings, new cam, new lifters, new timing chain and gears, all new
valves, in other words everything will be knew in the engine.  I also had
all machined surfaces checked flattened if necessary.  Also rebuilt fuel
pump and oil pump.  While I was at it I have also had the hydramatic tranny
completely rebuilt.  I do not intend to have to tear into this
engine/transmission once it is back in the truck.  

Jim V.
1958 GMC Suburban Carrier Pickup - V8 Automatic


At 12:12 PM 7/22/99 Thursday -0400, Hudson29@aol.com wrote:
>       Grant warned:
>
>       "You are coming dangerously close to being caught in the "might as 
>well syndrome". I've found once I start investing money and labor in internal 
>engine parts it's hard to stop or do half a job.  I either just run it or 
>rebuild it all."
>
>       He has, of course, put his finger on the nub of the problem. I 
>started this project intending only to clean and paint, then run the 235. 
>Unfortunately, the more I saw, the less I liked, I have small doubt that had 
>I "just run it", I would have "just towed it" also. The rub is where to stop. 
>With any luck, the bottom end will look solid and I will be able to 
>reassemble the motor with a glad heart.
>
>Paul O'Neil, Hudson29@aol.com
>1951 Chevrolet 3600 Pickup Project, See it at:
>The Poor Man's Advanced Design Tech Tips Page
>http://home.earthlink.net/~conntest47/
>Fullerton, California USA
>AEROMARK - Need Rubber Stamps or Signs? See:
>http://hometown.aol.com/hudson29/myhomepage/index.html
>
>Paul O'Neil, Hudson29@aol.com
>1951 Chevrolet 3600 Pickup Project, See it at:
>The Poor Man's Advanced Design Tech Tips Page
>http://home.earthlink.net/~conntest47/
>Fullerton, California USA
>AEROMARK - Need Rubber Stamps or Signs? See:
>http://hometown.aol.com/hudson29/myhomepage/index.html
>oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959

oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959

<Prev in Thread] Current Thread [Next in Thread>