> I think you have the original1953 flywheel on your 1957 engine. If the
> engine came out of a car it was probably an automatic. If flywheel has 9
> bolt holes you should get the larger clutch.
> Bob ADler
The 10 and 11 inch clutches only have 6 bolt holes. I would use the largest
clutch the flywheel has a surface for. Stay away from rebuilt pressure plates.
Mine was trash, as in out of balance. When I couldn't find a new one for the 235
application I bought one for a small block, it bolts right on. You will need the
proper through out bearing for the cast rather than stamped arm.
Grant 50 3100
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959