I'd like to add that if you take a razor blade and cut along the glass and
the glass setting tape it will help loosen its hold and the glass will come
out of the channel easier. Spraying some WD-40 along the glass to channel
area and allowing it to soak in for a while will help also.
Joe
-----Original Message-----
From: Billy Gibson <bgibson@internetwork.net>
To: Stephanie <stephanie@annexe.cwnet.com>; oletrucks@autox.team.net
<oletrucks@autox.team.net>
Date: Thursday, May 03, 2001 3:25 PM
Subject: Re: [oletrucks] removing vent window glass
>Very carefully
>Get two pieces of flat bar about three inches long wrap friction tape
around
>both ends of both bars,about 4 wraps each put the bars on each side of the
>glass, get a pair of vise grips clamp them to the bars and start working
the
>glass very slowly pulling outward with one hand and using a small
>screwdriver working the tip in the top and bottom of the glass and channel,
>that's where you have to be carefully because you can break the glass if
you
>put to much pressure on the glass.
>Good luck it worked for me and that's the way we did it in the 50's.
>HooT58
>----- OriginalMessage -----
>From: "Stephanie" <stephanie@annexe.cwnet.com>
>To: <oletrucks@autox.team.net>
>Sent: Tuesday, May 01, 2001 8:30 PM
>Subject: [oletrucks] removing vent window glass
>
>
>> how do you remove the vent window glass from the frame?
>> oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
>oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
oletrucks is devoted to Chevy and GM trucks built between 1941 and 1959
|