oletrucks
[Top] [All Lists]

[Oletrucks] Front Axle Orientation

To: <Oletrucks@autox.team.net>
Subject: [Oletrucks] Front Axle Orientation
From: "Doug W" <dwpumps@comcast.net>
Date: Sun, 11 Jul 2010 16:22:47 -0700
I am re-assembling the front end on my '56, but I cannot figure out the
correct orientation of the stock front axle. It almost appears like it can
go either way, except there are two wedges (called shims by the assembly
manual) which get installed between the leaf spring and the axle, and which
are dimpled to fit into two holes on the axle. These wedges or shims are
thicker on one end than the other. So their fit to the axle is not in
question. But how the complete axle (including these shims) gets bolted to
the leaf springs is my question.

 

At first, I figured the thick part of these wedges would go towards the
front, to give the entire axle assembly some caster (assuming the leaf
springs are level.) But then I tried reading the bolt and nut markings on
the axle and shock connection, and I'm now thinking that the thick part of
these shims (which dictate the axle orientation) should go towards the rear.

 

Can anyone on this list steer me in the right direction?

 

Doug
_______________________________________________

Oletrucks@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation  $11.47
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums

<Prev in Thread] Current Thread [Next in Thread>