[Top] [All Lists]

Re: [Shop-talk] dry cut metal saw

To: "john niolon" <>
Subject: Re: [Shop-talk] dry cut metal saw
From: "Paul Parkanzky" <>
Date: Wed, 9 Jan 2008 22:12:05 -0500
Morse makes a similar product called the Metal Devil saw blades.  There are
a ton of videos of them cutting all kinds of metal (plate, unistrut, angle,
etc) on their website.

On Jan 9, 2008 8:00 PM, john niolon <> wrote:

> I don't know if this qualifies as a "tip or trick" or more of a tool
> recommendations.
> Back a few months ago a member of the Ford site I frequent  told me about
> a
> dry cut metal saw blade that could replace an abrasive blade in a chop
> saw.
> They can handle the chop saw speed. They are made by Bullet Industries.
>  The
> 14" model (chop saw size) is about 50 bucks.  I ordered and finally got to
> install tonight.
> clamped in a piece of 2x2x<" angle iron and dropped the blade down.. It
> almost fell thru the metal !!!  If you've used a chop saw you know about
> pressure on the blade and the mess it makes.  Only the lightest pressure
> is
> needed...just let the blade do the work.  It's like a hot knife thru soft
> butter..  The output was very fine chips of metal that pretty much stay
> close to where you're cutting and not floating around in the air and up
> your
> nose like the abrasive dust.
> I can't say anything about longevity yet, but for speed of cut and ease of
> cut this is the best I've found... check them out below.  If you do a lot
> of
> fabricating and cutting... this really seems like the way to go....
> john
> All I ask is a chance to prove that money can't make me happy.
> _______________________________________________
> Support Team.Net
> You are subscribed as
> Shop-talk mailing list
Support Team.Net

Shop-talk mailing list

<Prev in Thread] Current Thread [Next in Thread>