< Made in USA, too. >
Well, I guess you can't have it all? :)
Robert D.
-----Original Message-----
From Ron Soave <soavero at yahoo.com>
>Never let it be said we-not-tight, but you can get a
>valve spring compressor that'll fit at Sears. That's
>where mine came from. Made in USA, too.
>
>--- Frank Clarici <spritenut@Exit109.com> wrote:
>> "Charles D. Sorkin" wrote:
>> >
>> > Good evening list:
>> >
>> > I have decided with some encouragement from Frank
>> to proceed with a rebuild
>> > of a 1275 head. (Engine block comes later.)
>> First problem: Where can I
>> > get a valve spring compression tool that will fit
>> this size head?
>>
>> Any hardware store.
>> Buy a large "C" clamp, drill a 3/8" hole in the
>> fixed end, use it as a
>> valve spring compressor by tightening the knob.
>> It also makes a great caliper press and, get this,
>> it makes a great "C"
>> clamp too.
>> Hey you needed a giant C clamp anyway!
>> Or you can borrow my giant C clamp. It is the only
>> thing I ever used on
>> Spridget valve springs.
>>
>> --
>> Frank Clarici
>> Toms River, NJ
>> Too many Sprites (again)
>> There is a very fine line between "hobby" and
>> "mental illness."
>> http://www.exit109.com/~spritenut
>>
>
>=====
>Ron Soave
>"Here we are now, entertain us!"
>
>
>IGNORE THE YAHOO MESSAGE BELOW!!!!!
>Do You Yahoo!?
>
|