spridgets
[Top] [All Lists]

Re: Day 3... success at last!

To: pixelsmith@gerardsgarage.com
Subject: Re: Day 3... success at last!
Date: Fri, 18 Feb 2000 20:57:45 EST
Cc: spridgets@autox.team.net
References: <v03130328b4d396554fdb@[209.24.234.36]>
Hooray!  Hooray!  Hooray!

Take the next two days off and enjoy the sunshine!  It's getting rare in
San Francisco!

Paul
PAsgeirsson@juno.com

On Fri, 18 Feb 2000 17:12:45 -0800 Gerard Chateauvieux
<pixelsmith@gerardsgarage.com> writes:
>I'm happy to report that today, besides being a delightfully warm 
>sunny
>day, I succeeded in getting the '75 Midget running with only a couple 
>minor
>obstacles.
>
>The problem with the fuel pump turned out to be twofold. One was that 
>the
>diaphram was "glued in place from having sat too long. The few drops 
>of gas
>I dribbled into the strainer yesterday, combined with a little gentle
>urging through the three strainer holes set it free again. The second 
>was
>that someone used some silicon rubber as a gasket cement for thr 
>rubber
>seal onside the cover. I think that was allowing air in (and gas out).
>After I removed all the silicon from the seal, it sealed just fine.  
>Now
>that fuel is flowing to the carb, I'm seeing a big puddle begin to 
>develop
>on the ground. I discovered that there is a plug in the base of the 
>float
>bowl with a dried up "O"-ring.  A trip to my neighborhood plumbing 
>supply
>and twenty cents cured that in a jiffy! After that the engine fires 
>right
>up and seems to run very good. No unusual noises and no smoke... not 
>even
>any leaks. I haven't been able to test drive it yet since the pedal 
>box and
>new master cylinder need to be installed, but so far so good.
>
>The one thing I haven't been able to figure out is where the 1/4 or 
>3/8
>inch vacuum connection on bottom-manifold side of the carb goes. This 
>is a
>brass pipe that is angle down and toward  the front of the car. Is 
>that a
>purge line? For now I just capped it, but if anyone knows please tell 
>me. I
>can't seem to find any reference to it in the manuals.
>
>Thanks again to everyone for their help getting me through this.
>
>Gerard
>
>
>
>G G              Gerard Chateauvieux
> E A
>  R R        pixelsmith@gerardsgarage.com
>   A A
>    R G          Pixelsmith  on  Duty
>     D E
>      S      http://www.gerardsgarage.com
>
>
>
>
>
>

http://dl.www.juno.com/get/tagj.

<Prev in Thread] Current Thread [Next in Thread>