http://owainlloyd.no-ip.com:8080/photos/Tiger/fuelPump/slides/CIMG4638.JPG
http://owainlloyd.no-ip.com:8080/photos/Tiger/fuelPump/slides/CIMG4639.JPG
http://www.bes.co.uk/products/145a.asp
scroll down to "Compression x BSP Parallel Female" - i think it was either
part 9477 or 9476.
On Mon, Jul 4, 2011 at 9:48 AM, Smit, Theo <Theo.Smit@dynastream.com> wrote:
> When I re-plumbed my fuel system, I kept about 3" of the 5/16" line
> including the compression fitting end, and soldered it into a 3/8" pipe that
> supplies the fuel pump. It's not as good as having 3/8" all the way but I
> figured the short piece of 5/16 would limit the difference.
>
> Theo
>
> > -----Original Message-----
> > From: tigers-bounces@autox.team.net [mailto:tigers-
> > bounces@autox.team.net] On Behalf Of Owain Lloyd
> > Sent: July 3, 2011 8:48 PM
> > To: genepadgett@comcast.net
> > Cc: tigers@autox.team.net
> > Subject: Re: [Tigers] Gas tank crossover tube fitting
> >
> > I have photos of the fitting somewhere. I will share later if you
> > like.
> >
> > the reason I did this job was I was getting dead spots at the end of a
> > long
> > straight on full throttle. this was the last 5/16 in the system and
> > 3/8 fixed
> > it.
> >
> > On Jul 3, 2011, at 22:20, genepadgett@comcast.net wrote:
>
>
> This e-mail and any attachments may contain confidential material for the
> sole use of the intended recipient. If you are not the intended recipient,
> please be aware that any disclosure, copying, distribution or use of this
> e-mail or any attachment is prohibited. If you have received this e-mail in
> error, please contact the sender and delete all copies.
>
> Thank you for your cooperation.
_______________________________________________
tigers@autox.team.net
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|
