Hi to all,
I'm a relative newcomer to TR6 and this list; I asked earlier about tires and
got a tremendously useful response, so I'll try again:
1976 TR6: the pressure to get the gearshift lever into the reverse gate has
increased, so now it's quite a hard push to get it over. Bently has an
section on adjusting the gearshift lever and it looks easy. Just wondering if
any of you have had this happen and if the adjustment in place has a good
chance of fixing it or will it require top cover removal and small part
replacement/adjustment. I don't think there's a problem with the reverse idler
or the shaft, since once the lever is in the gate the shift to reverse is
smooth.
Although I'm new to TR6 I have considerable mechanical experience from The Old
Days, and have done quite a few transmission overhauls so the more detail the
better.
Thanks a lot in advance.
George Loriot
1976 TR6
|